I have to send trigger signals from a capacitive touch sensor to biosemi through the USB receiver. The sensor output is 5V digital. I have soldered this output to pin1 of the DB37 connector. Pin 37 is grounded. I have left all the other trigger pins (2-16) untouched. My question is will the actiview software detect the trigger signal when pin1 goes to 5V.
I believe biosemi recognizes that the trigger pins are 'active high' when there is no input. should i ground the other trigger pins?
Thanks!
Trigger inputs through USB receiver
-
prasanth renganathan
- Posts: 1
- Joined: Thu Jan 24, 2019 10:48 pm
-
Coen
- Site Admin
- Posts: 1148
- Joined: Fri Mar 26, 2004 7:00 pm
- Location: Amsterdam, Netherlands
- Contact:
Re: Trigger inputs through USB receiver
> My question is will the actiview software detect the trigger signal when pin1 goes to 5V.
Yes.
> I believe biosemi recognizes that the trigger pins are 'active high' when there is no input. should i ground the other trigger pins?
Not necessary.
Best regards, Coen (BioSemi)
Yes.
> I believe biosemi recognizes that the trigger pins are 'active high' when there is no input. should i ground the other trigger pins?
Not necessary.
Best regards, Coen (BioSemi)